HOLD*BLAST by Chor*Rid International

HOLD*BLAST is a surface passivator which stops the formation of flash rust for long periods of time, often several days. Surface corrosion can occur when water-wet surfaces react with oxygen in the atmosphere, or with humidity in the case of a dry-blasted surface, resulting in flash-rust. The formation of flash rust can be eliminated with the use of HOLD*BLAST flash rust inhibitor. HOLD*BLAST is a concentrated organic chemistry which is added to water and sprayed onto surfaces during preparation for coating. It does not leave a film or residue to interfere with coating adhesion. HOLD*BLAST removes dust as it passivates and is a cost-effective, environmentally-safe, and biodegradable product.

HOLD*BLAST is applied directly to the substrate in a dilution of 1 part HOLD*BLAST to 50 parts potable water, to thoroughly wet the surface. Application can be made using pressure washing, airless or conventional sprayer, water-jetting, wet abrasive, or mist/vapour blasting. The washed surface is allowed to dry prior to coatings application. HOLD*BLAST will typically “hold the blast” against flash-rust for as much as 72 hours.

Because HOLD*BLAST is colourless, bio-degradable, non-flammable, and non-hazardous, and leaves no chemical residue, there is no need to rinse surfaces treated with HOLD*BLAST.  It does not cause degradation of application equipment; simply clean up by flushing with fresh water.

HOLD-BLAST has a shelf-life of up to 36 months, and partial pails can be tightly-closed for storage until the next use.

Home | About | New Products | FAQS | Tech Articles | Contact | Terms
Stone Tucker Inc. | Phone: 905-688-5800 | Email: info@stone-tucker.com
Copyright 2011 Stone Tucker Instruments Inc. | Niagara Website Design by Future Access Inc.